Recent content by cslinger

fenix-store
  1. C

    Will a Reylight Rook Run On A CR123A As Well As Its 18350?

    Thank you much. Chris
  2. C

    Will a Reylight Rook Run On A CR123A As Well As Its 18350?

    Basically is it a “dual fuel” capable light? Thanks all Chris
  3. C

    Potential body and tailcap for the E2XTL

    How do you have an E2XL running in low mode? They are single mode lights, no??? I’ve tried a 3 volt Malkoff head on an edcl-1 gas pedal light and still only get high(normal / single output).
  4. C

    Could you point me to an E-Series 18350 body?

    Thank you sir.
  5. C

    Could you point me to an E-Series 18350 body?

    Good day all. I am looking to Lego a Surefire E-Series head and tail cap with an 18350 body. Could anybody point me in the direction for this. I see lumens factory has an E1P 18350 body but there is no other info and I want to be positive it will fit e series heads and tails. Thanks all...
  6. C

    The Quark lights thread! (Part 6)

    1st and foremost. Is DHart the same DHart who is also a gunny and posts on many of those forums and if so what happened? Always seemed like a well spoken good guy, my condolances, for whatever he is going through. 2nd as to the guy with the light issue I would almost bet it is the little...
  7. C

    Do the quark tacticals have a parasitic drain?

    If so how bad is it? Will it drain a battery in an unused light fast? Thanks Chris
  8. C

    The Strion LED is out (pics)

    Not a strobe fan but have to agree with the above post regarding the UI. the UI is fantastic for a multi mode light that can be used as a simple on/off tactical light. Momentary works great, constant on is just a quick click away, strobe is simply a full double click from any level. I think...
  9. C

    The Strion LED is out (pics)

    I've run mine for a good bit / 20 minutes or so on high while outside and holding it in my hand and it didn't feel like it got HOT by any means. A bit warm maybe. So far I really like this light. Like the interface, run time, self discharge rate seems to be a non issue, great beam of light...
  10. C

    HDS B42 turned itself on, wouldn't turn off

    I would bet that is it then. That is the one annoyance with my older HDS lights, which are un-modded and I still love by the way. Sometimes when pulling them from the pocket of sweats they will cycle on/off or sometimes revert to the primary setting. You should be able to test the theory by...
  11. C

    HDS B42 turned itself on, wouldn't turn off

    They tend to do that.....................................right before they KILL!!!!! Sorry just joking, or am I? :D I have no idea why that happened. I do know my older HDS lights are susceptible to static turning them on or flashing them for a second.
  12. C

    The Quark lights thread! (Part 2)

    Re: Quark tactical UI programming So Carrot, if possible, could you explain the UI to me? So the twist head works like every other Fenix, correct? The tactical lets the user choose one (1) output for each twist position (tight/loose)? How does it get programmed? Does the tail switch offer...
  13. C

    Beamshots(bad ones, but beamshots :D) Strion LED, Novatac 120, Super-Tac

    Up close the Strion does have a bit of an outer ring. In practical use it is not noticeable. I think the reason the hot spots look similar is the spill from the white wall / exacerbating it. In practical use the NT120 has much more flood then either of the two Streamlights. The Super-Tac is...
  14. C

    The Strion LED is out (pics)

    See for yourself. :D I did a comparison of beamshots on HIGH for the Novatac 120, Super-Tac and Strion. They are crappy beamshots, as I really can never do a good job on these and they make all the lights look dimmer then reality but should give you some idea...
  15. C

    Streamlight Strion LED UI (Surefire, take note. This is how the E1B should be done)

    I don't think so, but you could hypothetically carry an additional charged Strion battery to drop in.
See more

Latest posts

Top