Thanks for the info guys. Decided to run it around the 300 mA range. tried attaching LED to my proposed housing.. got very hot very quickly!
Havent decided what i'm going to make the final version out of yet.. probably going to be all aluminium.
just need a small cylindrical housing with an...
I'm in the process of making a headlight for dentistry. Plan to run 1 CREE Q5 at either 350 mA or 750 mA. Diameter of the base of the unit will be 20mm just wondering how thick the alu bar heatsink should be. Ballpark suggestions or more accurate advice would all be greatfully received.
Dave
Re: Christmas Gifts V, are here!
hi, sorry for the delay had some problems with my computer..
I would like:
NUWAI ALX-33K22L, modified w/Cree +, donated by mhubble.
thanks very much guys, hope to be in a position to donate next year.
Re: Christmas Gifts V
Id like to be considered too please, another poor student!
Just like to wish all the donators and original creators of this idea all the best!
thanks very much, thought the claimed figures were a bit dodgy. Think i'm going to go back down the DIY route, just have to find a decent battery that doesn't cost a fortune in the UK now..
does anyone here have any of these lights? if so what do you think of them. Specs on the website seem a little optomistic.. quotes 450 lumens for the 605 and 350 lumens for the 305..
hi,
yes it is possible to construct a bridge using the adjacent teeth, this is mainly done for anterior teeth as the forces they experience are lower. The success of the bridge would depend on your occlusion and how your teeth function in excursive movements for example. The problem with bridges...
cheers for the help guys, just discovered my charger is not up to the job.. now looking into buying a new battery pack. is it possible to use camcorder batteries as i have a few decent capacity ones already if so how would i do this.. or am i better off buying a new Nimh/Li-ion.
I'm currently a...
Just wondering if it's ok to join two of these batteries (Amax 7.2v 4300mah- NimH battery pack for rc toys.) in series to make one battery pack. If so can you recharge them as 1 battery or would you have to charge them seperately??
Hi guys just wondering if anyone could help me design a LED system. i'm a dental student so the LED housing will be mounted onto the bridge of a pair of safety specs - needs to be quite light, will be using an external rechargeable battery pack. Doesn't need to be stupidly bright just sufficient...