VLow ~3.2V is compensating for the unprotected cells?
I don't have to worry about over discharge on protected cells I would have thought.
Hi Jimmy, I have edited my order post above. You may go ahead with the regs now.
Also, I will need the programming adapter to dial in them in later. Many thanks!
Ok Guys, what do you think of the setup below.
#1
Incan 3 Cell Li-ion
Operation Mode: Multi-Level
Vbulb: 7.5v
Vlow: 9.6v
Level-1: 15 (69%)
Level-2: 7 (47%)
Level-3: 32 (100%)
SoftRamp: Yes
Softstart: Slow
Low Volt Warning: Pulsing
Low volt shutdown: Undervolt: 92% (For a final shutdown of...
Let me see if I get this right.
To run within the bulbs limits with 4 cells, regulated at 14.4V, VLow set at 12.8V, correct?
Overdriving it to 16.4V would need 5 cells, regulated to output <16.4V, VLow set at 16V?
Thanks Conte, You just made my choices easier.
MT-G2 direct drive it is then, can it still run with multi-modes?
What I'm looking for the Incan, is the flexibility of reconfiguring the switches for different bulb and batteries combination will make it all fun giving different setups. Would...
Will adding another cell solve it? 2 cells for LED and 3 Cells for Incan. Looking at those Carley's to run but at least I have an idea on what I'll be needing.
By all means, let me know some of your settings. Maybe I can learn something from it, too.
As I understand the regs can be tweaked at a...
Hi Conte, makes sense that does.
How would you configure the regs to save the 9.6V-13V bulbs from flashing and also be safe for close to similar LED drop-ins?
Or maybe just build a different switches for Incan bulbs and another for the drop-ins?
Hi guys, thinking of running on 2 protected li-ions, maybe I miss understood what Vlow means. Not trying to be clever but I'm trying to build a versatile switch for Incan/LED Mag to regulate the voltage at 9.6V max. Appreciate if you can enlighten me