Hello all,
I know the experts are here so here I am, mainly because im stupid with this stuff but I know it. :) I need help with this project iam working on, the photo is of a front view/ footprint of what I have to work with. The solution I need is to fit 3 LEDs, as bright as possible (of...
We are looking for a company to assist in completing a project to include design and possibly production to include circuit board design.
Please contact us if your company has the capabilities to assist in this project.
thank you
[email protected]
Can you show me what you mean by a star please. Would you be talking about this, http://dx.com/p/star-connection-and-heatsink-for-cree-mc-e-led-emitters-parallel-5-pack-16545
If so I dont think I have enough room to use one at its size, can they be trimmed down to be used?
They will run...
Thank you videoman,
That is the conclusion I came out with, I have 10mm for each. Sorry I didnt clarify.
Would a resistor prevent the battery from going poof?
I did consider heat sinking and was going to use small aluminum "pucks" that I have seen soldered to the base of the led.
Iam a...
Hey guys, I have been reading on here alot and have learned a lot so far but I need a little help getting over this hump.
I plan on running 2 cree XPGs (http://www.mouser.com/Search/ProductDetail.aspx?R=XPGBWT-L1-R250-00H51virtualkey57280000virtualkey941-XPGBWTL1R2500H51) off a ipod battery...
Thanks for the advice, right now I need to have a "prototype" done and go from there.
Im new to this arena which is why Iam looking for assistance from the pros on here, do you think I should start another thread under another section?
as you can see im new to this forum as well, thanks again...
I need someone or a company to work with me to create a full custom housing and light under a full non disclosure. Possible full manufacturing if design works as designed.
serious inquiries only please
please contact me ASAP if you can do this.
[email protected]
Thank you, that helps me understand more how leds work more, atleast when comparing brightness.
I would say to be able to see 4 people at 20 ft from the waist up. I havent really shined a light on rats or rabbits so I cant compare to them lol
Can this be done with one led? or 2?
using small...
Outdoor use. The housing would be waterproof, im confident in building the housing. I just need help with the internals.
what I mean by 10-20 ft is that I want the light brightness to shine that far.
Im sorry if im not using the correct terms but as you can see by my low post count im a total...