Recent content by icthelight

fenix-store
  1. I

    Sold/Expired === Draco Reservation/Payment === (PART 2)

    :paypal: PP Amount: $310.90 PP Subject: Draco Payment PP Note: CPF Handle = icthelight === Order List === 1x Titanium 6AL-4V TiCN coating Draco ... $270.00 - FluPIC & Cree XRE 2x Extra oring ... $4.00 1x charging spacer ... $1.50 2x 10280 Li-Ion ... $9.00 1x Nano AAA charger ... $7.00 Tritium...
  2. I

    Sold/Expired Pre order ARC 4+ type clip steel

    Hope I'm not too late for this one.... I'm in for 2 steel clips with 2 pair Ti screws
  3. I

    Sold/Expired Introducing FLuPIC V2.1 firmware! Updated 8/4/2005

    PP/CC sent for 1 board. Interesting, I didn't think that regular epoxy had very good thermal conductivity. Thanks!
  4. I

    Sold/Expired Introducing FLuPIC V2.1 firmware! Updated 8/4/2005

    I also saw some pictures of a board that was covered with thermal epoxy. Where would I get this thermal epoxy, and does it actually cure like epoxy?
  5. I

    Sold/Expired Introducing FLuPIC V2.1 firmware! Updated 8/4/2005

    Got it, I would still use the original board for the battery contacts. These are $20 now? I'll take one. Do you have a paypal address?
  6. I

    Sold/Expired Introducing FLuPIC V2.1 firmware! Updated 8/4/2005

    Goldserve, Is the FLuPIC board a direct replacement for the original Q3 driver board - so I don't have to modify my original board, just remove it? I see the max current at the highest level is about 500 ma. How does this compare to the stock circuit? I have a SX1J in my Q3 that draws 720 ma...
See more

Latest posts

Top