Are there any good threads that have photos of the head dismantled? Would like to do a led conversion on the head and curious how much space is in it. After seeing some of the folks cramming 7 led's in the head I'm curious on a multi XM-L2 setup in that thing.
Bumping this older thread because it is what lead me to the shark buck. After searching the aqualab driver list(http://www.videofoundry.co.nz/ianman/laboratory/research/driverlist.php) it looked like the shark buck is the only one that fits what I think I'm looking for.
single mode, drive a...
Victor from http://www.usanodizing.com just got back to me over email. Very nice guy. They do small one off's. Quoted me $25 for a MIL-A-8625F Type III, Class 2 anodizing of one of my small pieces. Will send it to him this week and report back whenever I get the piece back.
There is a local place in Alexandria(www.alexandriametalfinishers.com/anodizing.htm) but it looks like their minimum order is $150... I need a place that doesn't have a minimum $ order. The pieces I want anodized are very small. Only have 3 pieces and all much smaller than a 2" cube.
edit---...
Re: P60 modules - warm, neutral, cool white/XPG- XML / SST-50 -90 P60 modules (part 9
Thank you Dave. I plan to primarily use 18650's. On the off chance I only had access to CR123's what would be the worst that would happen if I powered the drop-in by two CR123's? Kill the drop-in or kill...
Re: P60 modules - warm, neutral, cool white/XPG- XML / SST-50 -90 P60 modules (part 9
Re:Luminus SST-50 - 2.8-6volts direct drive - 1 Level direct drive
What cells are acceptable in these voltage ranges? One 18650, two CR123's, and two RCR123's? Guessing the two RCR123's would be too high...
Anyone know of a single mode XM-L drop-in that takes a huge voltage input range(2.7-9)?
http://www.batteryjunction.com/thrunite-p60-r5.html
Is close to what I want. XP-G with the 2.7-9 but I can't find one for sale where it's actually in stock.
Want a drop-in that can run off of one 18650...
Appreciate the info. I actually sent an email to him over his webpage but haven't received a reply. If this was a duty light I would go the route of purchasing from Dan. As it stands this is just for a personal piece. On top of that this is a mod I want to do so I'm curious if I have any...