Recent content by JanCPF

fenix-store
  1. J

    SPORTAC® P60 drop-ins ©2014 Eagtac™ LLC

    Thanks for doing the runtime test :thumbsup: Thats about the worst 'regulation' I've seen for a flashlight in a long time. Even AMC7135 type linear regulation is pretty good as long as your battery voltage is above Vf and the overall efficiency on one Li-Ion isn't too bad either if meassured...
  2. J

    Modding a SF KL4 Head and my indecisiveness

    I really wish there were somebody who would do modding service on my KL1 gen 1 or KL1 gen 2. I have even taken them apart (partially anyway) so I don't think it should be too hard, but it seems nobody are doing them anymore.
  3. J

    Sold/Expired TNT SingLED modules for Surefire incan E-series

    I just received my Singled with XPG2. These modules represent excelent craftsmanship! Really nice a clean work. The beam profile is one that I don't have in any other light I own. Extremely wide spill with a well defined hotspot. A lot of the lumens are going into the spill so it's kinda like...
  4. J

    Will an over-discharge li-ion battery explode?

    This a good question that I also haven't found a definitive answer to, but logic tells me that if it isn't holding any charge, it doesn't hold any energy and therefore can't explode/vent with flame unless one tries to charge it but I'm certainly not sure about this logic. I hope someone who...
  5. J

    Foursevens Quark Tactical QT2L-X Burst Mode review

    Yes I'm aware of that, but I already own the 200 lumen XP-G and there is also not much difference between 200 and 300, but 400 would (for me) justify an upgrade .
  6. J

    Foursevens Quark Tactical QT2L-X Burst Mode review

    Thanks for this excellent review. Is it possible to select a mode that runs 410 lumens throughout the runtime without the initial 800 lumens burst? High mode seem to be around 300 lumens - correct?
  7. J

    SPORTAC® P60 drop-ins ©2014 Eagtac™ LLC

    Re: SPORTAC® P60 drop-ins ©2014 Eagtac LLC Hmm - so it's apparently out of regulation on one 18650 and so no constant output runtime. It doesn't sound much different from the all the AMC7135 based drivers out there. I was hoping that finally a 2-3 amp buck/boost driver was developed in the P60...
  8. J

    Tri XP-G / XP-E P60 Drop-In

    Mac, do you have any runtime graphs with one 18650? Has it got fully regulated flatline output on one 18650? Thanks Jan
  9. J

    Standard QUARK vs XML?

    Here is an interesting discussion on the matter: http://www.candlepowerforums.com/vb/showthread.php?309724-XM-L-Color-Separation
  10. J

    Standard QUARK vs XML?

    Also beware that XML lights tend to have tint variation across the beam where as most XPGs have nice uniform color across the beam. Jan
  11. J

    Quick question - can I used my Pila IBC Charger to recharge 3.0v RCR123s?

    Oh didn't know that about the soshine cells - thanks for pointing it out Dave :thumbsup:
  12. J

    Quick question - can I used my Pila IBC Charger to recharge 3.0v RCR123s?

    In short - no. The Pila IBC charges to 4.15-4.18 volts which would ruin your 3.0 volt RCRs.
  13. J

    Cave Video /w lighting mods

    Cool. Nice video!
  14. J

    Manafont Stepless Brightness Control XM-L T6 200M Diver Flashlight (2x18650)

    Thanks for the feedback Dashrynn, I'll pass on it then.
  15. J

    Manafont Stepless Brightness Control XM-L T6 200M Diver Flashlight (2x18650)

    Anyone tried this http://www.manafont.com/product_info.php/stepless-brightness-control-xml-t6-200m-diver-flashlight-2x18650-p-7353 from Manafont? It's extremely cheap so I have my doubts about durability, but from the pictures it doesn't look bad. It's looks like a XTAR D06 clone but with two...
See more

Latest posts

Top