I ended up putting the LaCrosse cells in a John Deere remote control dump truck for my 2 year old :). They are performing really well. Previously, I put some alkaline in and it only lasted 5 minutes. I think I got a good batch of cells there. I do want to test the cells for capacity at some...
Thank you for the reply. A little late to form these cells now, though I will heed your advice on the charging currents.
What about the 1000mah AAA cells? I can't really form them in the BC900 though my older Sanyo charger can charge AAA @ 150ma. Is that the best route to start them out...
Re:?'s
I had one cell say FULL after putting ~890mah in, meanwhile the other cells said full after putting ~2150mah in. I took the first cell off that said FULL and it started charging again....for an hour plus now and it is still going. So far it added ~500mah to the original 890.
What is...
Thanks for the information. Good point about the "other charger." I do have an older Sanyo charger that charges AA @ 350ma and @ AAA t 150ma as I recall.
How should I handle the new LaCrosse cells (2600AA, 1000 AAA). Manual says to form them at 200ma. Am I gaining a lot of cell life by doing this to these cells or would 500ma be sufficient? Also, after a few cycles, should I up the charge rate at all?
Also, I have some new Eneloops. Same...
Re: Thomas
...as a note, if you order early in the morning before 8AM CST (though that link seems to disappear earlier than that), Thomas has the "early morning special" where you can add 2 eight cell holders for "free" though I think it adds $.30 to shipping total.
Oh, and when you get to...
I've been toying between these two chargers for a bit as well. I ended up choosing the BC-900 for the display (displays info for 4 cells as opposed to scrolling through the info for each cell on the MAHA) and the "freebes." Mine should arrive today via FedEx so once I get in there and fiddle...
Re: Initial charge on Eneloops, charging strategies. (AAA)
SilverFox,
Thanks for setting me straight with the models. This "heat" thing with the BC900 has me a bit concerned.
I have not seen the flier but that last statement was funny. I bought some of my Geotrax stuff there and those remote controlled trains and planes take 6AAA each (3 for the controller 3 for the train/plane)!!! I couldn't imagine NOT using rechargeable batteries in those toys.
Re: Initial charge on Eneloops, charging strategies. (AAA)
Do you have any similar heat issues (as discussed above) when charging @ 700ma?
...maybe I missed this in another thread, but why would LaCrosse come out with such a similar charger that has lower charge rates compared to the BC900...
Re: Initial charge on Eneloops, charging strategies. (AAA)
No, I don't think there is a v36. I was just wondering because I keep staring at this charger over at the ThomasDist. website :)
MAHA C9000 = 3 year warranty
LaCrosse BC900 = 1 year warranty
...I've read on here that the MAHA C9000 has some better parts though though I have not found people saying that their Lacrosse BC900 has physically broken, though with earlier versions, a few have appeared to have melted down.
I...