Thanks for the reply George.
I'm using a Li-ion 14.8 Volt battery 4400mAh.
I'm dimming my current triple with a 3 position swith wired into the dimm leads of the Buckpuck 3023 with resistors to go to about 700mA and 150mA.
Cheers.
Tony
G'day all,
I'm making a new Cree XR-E quad light and I need two buckpucks (1000mA).
Is there an alternative to the Luxeon buckpucks from Cutter ? I don't really want to spend $70 on two controllers.
I need to be able to dim the controllers by the way.
Cheers.
Tony
Ah, cool thanks.
Is there much difference between 500mA and 1A in brightness ?
Question comes from my other lights which run 3 in series. Is that running at 1A or other ?.
I want maximum brightness without changing to a new battery since I've invested too much money in the two I have now...
G'day all.
Just about to put together a 4x XR-E bike light and was wondering about the wiring.
Should I do the first or second drawing for a parallel wiring hooked up to a 1A Buckpuck then to a 14.8volt 4400mAh battery.
Ultimately I'd like to slot one pair into low mode with a dimming...
G'day all,
This is my first post on this forum, but I've been lurking here for a while.
I am building another prototype bike light and I have struck a problem.
I'm using 3 Seoul stars and a 3023 model buckpuck with dimmable control.
The problem is that when I put a resistor across the CTL...