Recent content by x59628
-
X
EDC Pen?
I almost dislike the fact that everyone only mentions the Fisher Space Bullet. A lot of people buy it, don't like it, then call Space Pens peices of junk. The Bullet is really a low cost pen, and was not designed to meet a lot of specs. Personally, I carry the AG7. It's the original pen that Mr...- x59628
- Post #264
- Forum: Personal Gadgetry & Non-flashlight Electronics
-
X
What lubricant?
I've been using this "three in one oil" that I got from Walmart (its manufactured by WD-400) its a lot thicker than WD-40, and so far, it's worked great in my Fenix for both the threads and O-rings.- x59628
- Post #137
- Forum: General Flashlight Discussion
-
X
My new P3D water test video
with the L2T v2.0, you can turn the bezel under water as much as you want, as long as you keep the o-ring greased well. They are rated at IPX-8, so they were designed for continuous submersion. Sometimes when my Fenix gets really dirty, I take it into the shower and jet it with some hot water to...- x59628
- Post #13
- Forum: LED Flashlights
-
X
New commercial for Fenix lights!!!
I think for the waterproofness part, they should have dunked it in a tank of water rather than just showing that it could survive a thunderstorm- x59628
- Post #37
- Forum: LED Flashlights
-
X
Batteries for my L2T v2.0
Well, on the fenix-store webiste, it is the Fenix L2T v2.0 Q2 but on the features sheet that came with the light, it said 7090 XR-E LED Q2 could possibly be another name for the 7090 XR-E? Anyways, I like 7090 XR-E it just sounds cooler.........:D- x59628
- Post #8
- Forum: LED Flashlights
-
X
Batteries for my L2T v2.0
Wait, but chevrofreak has the rebel version. my L2T v2.0 has the Cree XR-E emitter is that more efficient than the rebel emitter?- x59628
- Post #5
- Forum: LED Flashlights
-
X
Batteries for my L2T v2.0
ok, so I have the Energizer 15 minute charger that has 2200 mAh NiMh rechargable cells in them. I was wondering if it would be brighter in the Fenix L2T v2.0 than a standard Duracell 1.5 volt AA cell. I know some of you will suggest other batteries, but I have a really big pack of Duracells...- x59628
- Thread
- Replies: 8
- Forum: LED Flashlights
-
X
My Fenix L0D went POP!!!!...
what most likely happened is that if the light was on the whole time, it would drain all the power from the cell. Most manufacturers make their cells so that if the voltage goes below safe levels, they "vent", releasing caustic acid. This is to avoid having the cell walls rupture later on...- x59628
- Post #25
- Forum: LED Flashlights
-
X
Nite Ize LED Upgrade for Mini-Mag; failure
I suggest getting their 1 watt Luxeon / IQ switch combo for $20 it's pretty bright and the switch is waterproof too!!! it will last a long time, although after about a half year of EDC, the circuitry in the switch started to rattle. It no longer works. Do be aware that the LED module is sorta...- x59628
- Post #17
- Forum: LED Flashlights
-
X
How to replace Fenix tailcap switch boot
lol, yeah 1. I'm only 14, so no beer for me :buddies: 2. There are only 3 components in the tailcap + the rubber boot :lolsign:- x59628
- Post #13
- Forum: LED Flashlights
-
X
How to replace Fenix tailcap switch boot
Ok, FINALLY worked!!! THANKYOU VERY MUCH!!!:twothumbs- x59628
- Post #11
- Forum: LED Flashlights
-
X
How to replace Fenix tailcap switch boot
I see....... thanks again!- x59628
- Post #9
- Forum: LED Flashlights
