grnamin
Enlightened
I've had this McClicky at least a couple of years now and I finally decided to try to mount a clip to it. Here's what I did...
1) Bent a piece of titanium to fit onto the back side of one of the slots of the McClicky.
2) Drilled and tapped two holes.
3) Shaped and test fitted the tiny plate onto the switch head.
4) Mounted the clip with two torx screws.
5) Finished up by sandblasting and heat-coloring the plate, screws and clip.
1) Bent a piece of titanium to fit onto the back side of one of the slots of the McClicky.
2) Drilled and tapped two holes.
3) Shaped and test fitted the tiny plate onto the switch head.
4) Mounted the clip with two torx screws.
5) Finished up by sandblasting and heat-coloring the plate, screws and clip.
