Kenom
Enlightened
I've been asked by a friend to repair his Wicked lasers E3 laser as well as his buddy's broken E3. Seems pretty pathetic that out of 3 that was purchased, 2 have died within days. It's my belief that they are using PHR-803T diodes in them and they are dying prematurely by being overdriven. Needless to say, the host is being recycled and a 500-700mw bluray diode is going to be going into these hosts.
Using a aluminum rod small enough to fit, I pushed out the front end the entire module and driver.
pretty simple to fix all this considering it's so simple to remove everything. Should be fun.
Sadly, I did break off the inductor, but I think I can replace it if needed. I am not however, using the stock driver. The 12x bluray diode that's going in here needs more current than this driver was providing probably. Still, it would be nice to have it fixed.
Using a aluminum rod small enough to fit, I pushed out the front end the entire module and driver.
pretty simple to fix all this considering it's so simple to remove everything. Should be fun.
Sadly, I did break off the inductor, but I think I can replace it if needed. I am not however, using the stock driver. The 12x bluray diode that's going in here needs more current than this driver was providing probably. Still, it would be nice to have it fixed.
Last edited: