Hi,
really old thread, maybe earth turned around many times? But i have also a question regarding the heatsinking of the board.
If i have to glue the driver with the outer ring, wich is also ground, to the aluminiumtube using arctic alumina will it still be connected to the tube? Or will this arctic shield the current, insulate? How do you do that?
I ordered a typical Kaidomain 3040mah driver board with a spring in the middle. The instructions manual says to glue it. If i would press it down onto its seating and would glue it from the topside, do you think there is enough heatsinking, and also resistance is low enough alos over time to guarante proper connection?
Is there anybody who already tried? I think so...
THX a lot..
regards
Henning