- Wiz2, low level? And does it need heatsinking?
- Still sell the MJLED?
- Prebuilt adjustable (Not Wide Open) sandwiches
- madmax - mulitlevel output?
- Aluminum Mag reflector Hole dia.??
- BB or MM powering Luxes conencted in series or parallel?
- Badboy 750mA
- Driver suggestions
- Light Engine Kits
- Wizard2 Questions?
- Convertor board for 5W?
- BB1K?
- Smoked a BadBoy
- Need board measurements, please
- PM6 Lens Question
- Want to build a UV Aleph -- what EXACTLY do I need?
- Can the Downboy 750mA power 3x Lux III's in series?
- any way to squeze more than 1 amp out of a downboy?
- Resistor value for 2 stage switch
- Could somebody post the info printed on the top of the Downboy inductor?
- Questions about an old MadMax+ adjustable I picked up
- 1.5v input sammie
- Performance of DB 750 with 3.7v R123s?
- Which Driver ?
- Edited (Empty)
- question about Aleph lens and o-ring
- Build question for Wayne
- What Resistor Value(s) Do I need for the converter board to power a Cree LED?
- Will this work for a Lux V?
- Nichia Jupiter (or equivalent) ship to UK?
- Aleph Tailswitch Question
- Aleph 2 w/DB917 in stock?
- Can Downboy take slightly more than 16v?
- WW0S, BB750, Li-Ion 3.7V ?
- 3 x RCR123 on DB750?
- Some questions about the Shark driver
- HD 45 Driver board change.
- NG500 versus MMPlus
- Lens question
- New McGizmo Reflector confusion!
- trouble ordering
- MadMax Lite Sammie Questions
- McE2s Standard (Nat HA)
- downboy convertor blown??
- NexGen750
- Can Downboy power up 2 or more luxeons?
- NG1000 TWOK & TWO primary CR123A ???
- Shark with 4 LuxIII's + 12 SLA, will it work?
- PQS & new round slug?
- Why does downboy say Buck/Boost... isn't it just a buck circuit??