- 4A output Driver. Fact or Fiction?
- Fitting KL1 head and tailcap to sf series cr2 body
- GD1000 vs SOB 1000 on 4 alkalines
- Simple question...A19 clip?
- GD Converter Open Load
- Aleph CR-2 Availability
- McLux PD boards
- Mule LE will these components work?
- Aleph Mule head in Ha Natural?
- GD Weird Behaviour & Bad Luck!
- Rebel MCPCB : what is that
- Aleph light engine build
- P7 Driver in the works?
- McR19XR & McR17XR - How do they compare?
- 1D to 4AA Battery Holder availibility
- McR-27XR Reflectors. Will they be stocked again?
- Weird SOB/resistor problem
- Will the be more McR19-XR's put on the site soon?
- Is a Bare Al Mule head available at the Shoppe?
- Driver for 3 XR-E on 3 Li-ions
- How do I get 1.5 amps from a SOB board?
- What converter board should be made next?
- GDx3 "BigMac" Converter @ 3.3A
- Driving 8 Cree Q5's with 4 AW C cell lithium ions
- Irakongi driver: Information and Interest
- A19 + Seoul GDuP + McR-19
- Thanks for making the makita adapter
- Making a tailcap for MCE2S switch?
- Need some direstion
- Too Many Choices...Suggestions for 2-Stage TailCap for Surefire E-Series?
- GDuP engine height vs. normal engine height...
- What parts for a flat tailcap for SureFire E series?
- GD1000 maximum output current? (with changed resistor values)
- Aleph question.
- Need advice on MM@g sandwiches
- Badboy, MM, NG, & Li-Ion
- 0.027" thick Copper Disc - what are they used for?
- Which lights can run on our Light Engines?
- Shoppe down for Maintenance . . .Back online
- Modamag's M2 Reflectors
- Any P7 LEs on the horizon?
- SOB 1000 + 4D Maglite + Seoul P4 = Questions
- GD1000 flashing
- MUCH IMPROVED:- 2-stage tailswitch heating up on low
- How do I select a light engine?
- GDuP, can we change the drive currents via resistors?
- GD1000 driver, which is Ground? -ve?
- custom converter for cell phone?
- Perfect Emitter Sink (PES) Update.
- A short break