- Circle Cutter and WriteRight = Happiness!
- Centering workpiece on 3 jaw chuck
- 6" Digital calipers at HF $15.99
- Centering workpiece on 4 jaw chuck
- Shortening Mags...how hard?
- What kind of foam for kydex press?
- Need Help from Experienced Machinist
- Removing HA3 success
- Error while posting a lathe program in mastercam
- making a reflector out of bare aluminum
- Maglite thread
- mini-mills
- Optical interfaces and integrating the dome?
- Polishing Magcharger reflector
- gluing kroll?
- Applying Glow paint/powder to Hotlips
- QIII reflector mod - polished down to remove sputt
- Optic raw material
- Soldering aluminum, please help!
- Mini drill press needed for...
- Seeking machining (lathe) mod services
- best way to remove bezel, Arc LS first run?
- Knurling gone wrong --- I need help !
- E1e/E2e bezel
- Resistance of a piece of steel
- Smallest diameter taps
- Solvent for Artic Alumina
- Need lathe services
- PM6 LED clickie in an ARC LS
- Brass as a heatsinking material
- Remove ARC black finish
- strongest wire
- NX05 optic is a 2 part piece!
- TI tubing for sale....
- Want A Good Clear Liquid Plastic
- Titanium alloys: Electrical conductivity?
- Adhesive for reflector? (Longbow mod)
- Thread Dimensions Needed
- Prevent corrosion with Galvanic Series chart
- Which makes a better reflector?
- Anodizing @ Home, Tips & Tricks ;-) , In Colors :)
- Need help bending copper pipe
- Need source for small copper or aluminum discs
- 1st Attemp to build a light
- Very small lenses/watch crystals
- Rayovac Kiddy 1Watt Luxeon MOD !
- FYI: Seattle area, lathe $50
- Sources for glass/plastic lens
- Thermal management optimization.
- Where can I buy a 13/16-20 bottoming tap?