Re: Why Not McGizmo ?

Re: does arctic silver thermal adhesive smoke?

If it is used to glue the emitter to a star/heatsink:

I have used Artic Silver adhesive (silver variant) on SST-90 builds, which does the

Re: FM3X & FM3H-3 Turbo Head By FiveMega

#02 Nickel plated FM3X (without reflector) $140
Extra chrome plated bezel $20
Extra Boro lens $10

#48 Black

Re: DEFT-X OMG Strikes Back!!!

Re: Surefire Outdoorsman E2L AA Help!

I wholeheartedly agree with the sentiments expressed in the following two posts:





I don't have the E2L-AA, but

Re: Test/Review of Eneloop AA HR-3UWXB 2450mAh (Black)

In the eneloop datasheet they test down to 1 volt, but remember this is under load.

Re: Good (and bad) OEM Headlamps

It sounds like my Honda CR-V's headlamps may be the worst of both worlds, then. They are VOR, yet still produce a stair-step down on the left side of

Re: Solarforce or Maglite

Thanks. I am leaning towards the L2P. As of today, I have been looking at the version with the 3-mode XM-L T6 8.4V LED. I want to run the torch on 2x

Re: Mechanical Modding Services

In theory yes, not too different from boring an E-series. I don't offer that service because the cost of a slip up is many times higher than the potential

Re: FF4 VS FF3

You have to email him on that arrangement.