No, I have this model http://www.harborfreight.com/120-vol...der-61205.html . I replaced the lower tong with a piece of high conductivity copper
Nice spacing! Never heard of them before.
Can't tell from your emoticon if you're serious or not but in any case the U3 is, I believe the highest flux bin for the XM-L2. Theoretically it's the
The S3 had no issues. They have changed the design lately though.
Sent from my iPhone using Candlepowerforums
I have two drivers sitting here one is 17mm the other is 20mm. I need to know where the +/- wires get soldered to. How many amps do these push ? Any help
Just picked up a Coleman CHT 10 Signature Headlamp and first thoughts is that it is a nice headlamp for the price. I will be doing a review once I have
I would look long and hard at the Armytek Prime A2.
I have the S2.
And one more thing to note: other than S2, all other models seem to have problem fitting protected 18650...
Care to share some photos of the dropin?
About the cable, micro USB is limited to 1.8A so isn't suited to provide the needed 2.1A for the VC4 to go full throttle so they needed to use something
Awesome pics as usual, Don.
Competition pod? Humpback Races???
Too bad about the Good Times. I'd be seriously bummed.
On 1 Eneloop (Selfbuilt measurement, which I find too lenient) but I think ~600 on 2 Eneloops (better be new and ideally XXX)
I got a P60 TIR from Vinh a couple of years ago. I think it was an XP-G, 3 mode 20-200-500 narrow optic. He may have more parts to build another.