KDOG3
Flashlight Enthusiast
I bought the McE2S assembly for C series Surefire lights from the Shoppe and I notice the resistor plate is too large for the E series lights. Can I replace just the plate or is the whole E series assembly different?
-
You must be a Supporting Member to participate in the Candle Power Forums Marketplace.
You can become a Supporting Member.
GAH! My McE2S is too big for my E1e tailcap...any ideas?
- Thread starter KDOG3
- Start date
Help Support Candle Power Flashlight Forum
I think you need to buy this kit instead of the one you have
LINK
That should fit aleph TC as long as e-series surefire TC
there are members who will tell you alot better then me, but i think i have this right....
good luck
LINK
That should fit aleph TC as long as e-series surefire TC
there are members who will tell you alot better then me, but i think i have this right....
good luck
KDOG3
Flashlight Enthusiast
ANyone else with an opinion?
wquiles
Flashaholic
Sounds like nakahosi is right on the money. I think you bought the "wrong" one, but Wayne at the Shoppe should be able to sell you the resistor board for a couple of bucks 
Will
Will
KDOG3
Flashlight Enthusiast
Well i didn't buy the wrong one - I was using it in a z-41 tailcap on my L5.
Thanks for the info, just picked up a E-sized 30-ohm resistor board from the shoppe...
Thanks for the info, just picked up a E-sized 30-ohm resistor board from the shoppe...
Last edited:
