I'm trying to create something similar to the item shown here:
Does anyone know what these LEDs are?
What are the items labeled 111? SMD Resistors?
I want to use the Luxeon K2 LEDs. I now need to figure out how to efficiently power the LED's and how many of them I can have.
Below are pictures of the factory angel eye setup:
The bulb shinse into the two fiber rods seen in the second picture.
What this LED setup needs to do is focus its light into those rods.
Options:
1) If there wont be any heating problems, two K2's next to each other, one focused at each end of the rod.
2) If two K2's are two hot, then it would be 1 K2 centered between the two rod ends.
Currently I'm looking for alternatives to the LuxDrive BuckPuck 1000mA DC LED Driver. The one I've found is Triad Magnetics 26W 2-36V 1000mA.
Any suggestions, help, comments, etc?
Does anyone know what these LEDs are?
What are the items labeled 111? SMD Resistors?
I want to use the Luxeon K2 LEDs. I now need to figure out how to efficiently power the LED's and how many of them I can have.
Below are pictures of the factory angel eye setup:
The bulb shinse into the two fiber rods seen in the second picture.
What this LED setup needs to do is focus its light into those rods.
Options:
1) If there wont be any heating problems, two K2's next to each other, one focused at each end of the rod.
2) If two K2's are two hot, then it would be 1 K2 centered between the two rod ends.
Currently I'm looking for alternatives to the LuxDrive BuckPuck 1000mA DC LED Driver. The one I've found is Triad Magnetics 26W 2-36V 1000mA.
Any suggestions, help, comments, etc?