Well I finally got this finished!
1 shiny Mag
1 Shoppe Shark
3 Lux III
9.6v of NiMH power
350,000 hours in the machine shop (seems like it...)
equals one bike light... priceless
And it even works! :rock:
Decided that I really didn't need the body...
Most of the time devoted to this was to make the handle bar clamp. It started off as a solid 2" bar and wound up looking like this...
I've learned that it takes much less time to use a drill bit than a lathe
to make a hole...
Notice that the bottom of the head has been machined down to match the top of the mount.
And a little bit of heat srink to protect the bike.
And the mounting holes so it all stays together.
Also makes a handy table lamp
(Thanks to Modamag for all his help!!!!!!!)
1 shiny Mag
1 Shoppe Shark
3 Lux III
9.6v of NiMH power
350,000 hours in the machine shop (seems like it...)
equals one bike light... priceless
And it even works! :rock:
Decided that I really didn't need the body...
Most of the time devoted to this was to make the handle bar clamp. It started off as a solid 2" bar and wound up looking like this...
I've learned that it takes much less time to use a drill bit than a lathe
to make a hole...
Notice that the bottom of the head has been machined down to match the top of the mount.
And a little bit of heat srink to protect the bike.
And the mounting holes so it all stays together.
Also makes a handy table lamp
(Thanks to Modamag for all his help!!!!!!!)