Soldering help.

rizky_p · Sep 17, 2007

I am not sure where to post but hopes that you ccn firgive me

hi can anyone help me solder a wire-wound that part of the boost circuit, the problem is the 2 contact areas is beneath the componen(SMD?) what tools do i need to do the job right? i tried using normal soldering to be too difficult.

Thanks

Flash_Gordon · Sep 17, 2007

Get two short pieces of insulated wire.
Solder one end of each to the pad on the board.
Turn your component upside down.
Solder the other ends of the insulated wires to the leads on your component.
Use a small bit of epoxy to secure your component to the board if necessary.

This should prevent damaging the board or your component.

Mark

rizky_p · Sep 17, 2007

didnt think of that before nice idea, lets hope that my skill is up to the task. I was thingkin of re-flow soldering but that is probably above my current skill and tools.

Thanks.

Soldering help.

rizky_p

Flashlight Enthusiast

Flash_Gordon

Flashlight Enthusiast

rizky_p

Flashlight Enthusiast

Similar threads

Latest posts