Drawing from inspiration i got from this forum i been planning to do one of these for a long time and today i finally completed it! I'm quite happy with the end result.
Torch specs:
my custom heatsink with locating grooves and 0.2mm gap between the infamous positive slug.
beam shot
p7 into stock reflector is a very tight fit
all in 1 package. connected using 3amp pc fan connectors
Custom driver based on AMC7135
Programming the microchip on the driver board.
Torch specs:
- 8*AMC7135 regulator
- ISP programmable ATTiny 45, controls the amc7135
- C-bin P7 2.8amps @ 3.5V
- currently programmed to switch modes with tapped on for 0.5secs(programmable) because the maglite switch can be used for momentary on
- 4 modes at the moment, 1%, 10%, 50%, 100%, direct drive mosfet for 150% in the future
my custom heatsink with locating grooves and 0.2mm gap between the infamous positive slug.
beam shot
p7 into stock reflector is a very tight fit
all in 1 package. connected using 3amp pc fan connectors
Custom driver based on AMC7135
Programming the microchip on the driver board.
