I have done this twice now like a big dumb a**. I put my AW RCR123 on the Nano charger and then forget about them? They probably were left on the charger for 2 hours after the light had turned green. Now either one really wants to work in my light. Are they done? Thanks
Did I ruin my RCR's
- Thread starter skunksoup
- Start date
Help Support Candle Power Flashlight Forum
Christoph
Flashlight Enthusiast
What is the resting voltage of these cells now?
C
C
tebore
Flashlight Enthusiast
The nano charger shouldn't over charge if anything they under charge the cells.
This is from my experience with the Nano. The cells charge slow and the light turns green when the cell is around 4.12v. Leaving it after it's gone green may make the cell hit 4.15v.
This is from my experience with the Nano. The cells charge slow and the light turns green when the cell is around 4.12v. Leaving it after it's gone green may make the cell hit 4.15v.
Christoph
Flashlight Enthusiast
My nano will take a cell to 4.3-4 v If I leave it over night.
LukeA
Flashlight Enthusiast
Is that overcharge rate protection or overvoltage protection?
tebore
Flashlight Enthusiast
Should have both. There's no overcharge rate protection AFAIK I think you mean over discharge.
Sgt. LED
Flashaholic
After a bit of a rest I would just go ahead and use them.
Well now I think I'm going to have to either move this post or start a new one? My creemator started acting up again last night but now it will only stay on high? No other levels work at all? I did run the RCR's with my M60 and they did fine. So it has to be the light? Right??
