A few shots of our CNC XPE bike light.
630lm out the front
R2 XPE LEDs driven by a blfex driver.
so here is a mock up of how it all goes together, it should be super quick to build, & can be fully pulled apart to swap / upgrade parts if needed. not shown is the bar clamp, its still being made...
Driver goes in (sits on top of a o-ring)
Driver holder goes in
Rear cap, pushes on the driver holder. Rear cap will have a cable gland coming out of it & the bflex onboard warning LED will glow through this.
Rear cover screw on, sealed by 1 o-ring & waterproof grease on sides of rear cap.
LED pcb drop in
Optic, o-ring, glass or lexan lens, o-ring & front bezel