Okay, then you are 100% correct.
I purchased this MC-E P60 drop-in on direct drive from Gene Malkoff. He said the Lumens would be at least over 1000 out the front because of the lower forward voltage of the MC-E.
Behold my 1000 Lumen Surefire E1e w/6P bezel and IMR 16340. I get 4.5A at the tail so it is over 1000 Lumens.:twothumbs
Right !!!!
Proof ? I have no Proof .. + Im not ignoring anything ..
Just telling you I haven't done it ..
If my D-bin is incorrectly rated , and it cant do 450Lumen @ 1.6A ?
I dont have a light sphere , so I can only do the math . Is the math wrong ?
If your saying Im not taking Heat Sag / Battery Sag into account your 100% right .. It takes me 10 - 15 seconds to get a good reading and thats it .
Im currently not interested in 5 minute runs as thats not what I'm interested in , I dont run my MC-E or my SSC P7's that long , at best 60 seconds , the rest of the time is spent on Lo .
ATM all I want is 3 P60 pills that are ready to go with 3 different levels of performance [ AMPs to LED ]
Around 1A / 1.6A / and 2.4A or better ...
Then I want to see ! Till then ill quote current to LED and factory spec's for said current/performance , to your obvious disgust ...
Just like everyone else seems to do . :wave:
I appreciate the time and effort you have gone into , but
yelling dont help
Just conveys something different to me ...
To the DDs ... Two were average , one was outstanding , and did not suffer from sag for a full 60 seconds or more .. :nana:
Doubt it you can , but here's the thing , Im not selling anything to anyone , I dont want to buy anything from anyone .
I just want to have some fun with flashlights !
And if a SSC P7 D-bin cant do 450 Lumen @ 1.6A to the LED ?
Then you better explain why , rather than give me results from previous tests . Because if there is one thing I know , there is no constant .
No two pills will ever be 100% the same ... No two batteries etc .
This SSC P7 D-bin ---
Removed from star
Base was lapped flat
Alumina Epoxied [ non conductive ]
Known Driver output . [ 10% Loss ]
1.8A at tail = 1.6A to LED [ Average for my batts ]
Pill , wrapped in Al-foil - tight fit into body [ Very Tight ]
Body = Ultrafire 502B
So what is the LED output ? or should I say starting output ?
Again , no out the front , just LED .