I have bought some xp-g R5 on the 10mm round mpcb board and I have a few questions.
1. Can I solder to the small pads on top of the led?
2. Do the pads on top have a protective coating? How do I remove it?
3. Is the negative side of the LED (-pad on top) connected physically to the mpcb?
4. Any tips on soldering to xp-g with mpcb?
1. Can I solder to the small pads on top of the led?
2. Do the pads on top have a protective coating? How do I remove it?
3. Is the negative side of the LED (-pad on top) connected physically to the mpcb?
4. Any tips on soldering to xp-g with mpcb?
