meeshu
Enlightened
Just received my Jetbeam Jet-III ST BVC light recently.
Seems to be a well built, solid light, with nice styling! :thumbsup:
First thing I noticed was that the bezel anodizing is darker than the body and tail. Not a major issue, but it's something I'm not entirely happy with. :sigh: And no, the light is not for sale (yet).
I reprogrammed the three available modes by setting brightness levels to those I'm most likely to use. The method of entering programming is to half-click the clicky switch three times quickly while the light is switched on in one of the available modes. The reprogramming seemed to work OK.
Today, I wanted to make slight adjustments to the brightness levels. But to enter programming NOW, I have to press the switch TWO times quickly!? Now, if I press the switch three times, the light will jump to the next mode and start to adjust the brightness level for that next mode instead of the mode I wanted to adjust!?:thinking:
I might be mistaken, but I'm fairly certain I did three clicks when first reprogamming the light. But from today, now it only requires two clicks.
I did switch the light on and off, and cycled through the modes/levels, including strobe, several times since first reprogramming. I'm wondering if, by mistake, I changed the programming access to two clicks instead of three???:thinking: Or was I initially mistaken about the number of clicks required to access programming?
My understanding is that this is one of the latest batch of lights manufactured. Maybe the number of clicks required to access programming has now changed to TWO clicks (even though the manual continues to mention three clicks)?
Any ideas?
Seems to be a well built, solid light, with nice styling! :thumbsup:
First thing I noticed was that the bezel anodizing is darker than the body and tail. Not a major issue, but it's something I'm not entirely happy with. :sigh: And no, the light is not for sale (yet).
I reprogrammed the three available modes by setting brightness levels to those I'm most likely to use. The method of entering programming is to half-click the clicky switch three times quickly while the light is switched on in one of the available modes. The reprogramming seemed to work OK.
Today, I wanted to make slight adjustments to the brightness levels. But to enter programming NOW, I have to press the switch TWO times quickly!? Now, if I press the switch three times, the light will jump to the next mode and start to adjust the brightness level for that next mode instead of the mode I wanted to adjust!?:thinking:
I might be mistaken, but I'm fairly certain I did three clicks when first reprogamming the light. But from today, now it only requires two clicks.
I did switch the light on and off, and cycled through the modes/levels, including strobe, several times since first reprogramming. I'm wondering if, by mistake, I changed the programming access to two clicks instead of three???:thinking: Or was I initially mistaken about the number of clicks required to access programming?
My understanding is that this is one of the latest batch of lights manufactured. Maybe the number of clicks required to access programming has now changed to TWO clicks (even though the manual continues to mention three clicks)?
Any ideas?