Looking for good driver for Triple CREE XML T6
- Thread starter nilesh
- Start date
Help Support Candle Power Flashlight Forum
BrianMc
Enlightened
- Joined
- Nov 4, 2009
- Messages
- 940
http://taskled.com/lflex.html $25 and shipping. Of course you will likely set it at 3 A and forget it. Taskled drivers are the gold standard.
kwarwick
Newly Enlightened
Isn't LFlex designed to drive a single LED? OP was asking about driving a triple XML light, so for that application I'd say H6Flex http://taskled.com/techh6flex.html would be a better choice.
Hi nilesh,
There are several good drivers that come to my mind. The H6CC can drive 3 XMLs and it is rated at 24V max. If for some reason you need multilevel brightness the H6Flex is another option. If you are not familiar with the use of these you should read up though.
http://www.taskled.com/compare.html
I think you could also use a shark buck, I am not a 100% sure what the max voltage on it is though so you would need to double check.
http://theledguy.chainreactionweb.com/product_info.php?cPath=48_49_61&products_id=1244
There are several good drivers that come to my mind. The H6CC can drive 3 XMLs and it is rated at 24V max. If for some reason you need multilevel brightness the H6Flex is another option. If you are not familiar with the use of these you should read up though.
http://www.taskled.com/compare.html
I think you could also use a shark buck, I am not a 100% sure what the max voltage on it is though so you would need to double check.
http://theledguy.chainreactionweb.com/product_info.php?cPath=48_49_61&products_id=1244
BrianMc
Enlightened
- Joined
- Nov 4, 2009
- Messages
- 940
Yes, it is. My bad.
brad72
Newly Enlightened
I used a hipflex to drive my triple xml with a maximum output current of 2800mA. Very, very bright
