Hallo, i'm new in this forum, this is my first post.
I'm Italian, apologize for my english.
I'm about to build on the lathe my first led torch.
As you see from title, I'm puzzling about a definitive solution to Drive a Triple Cree xm-l t6 board.
This is the link:
http://www.led-tech.de/en/High-Powe...REE-XM-L-T6-on-round-PCB-LT-1749_120_117.html
I just read the article describing the explosion of Ultrafire 3000 and I'm really decided to avoid putting the batteries in series to avoid that!
I have 3 2800mah driver
This is the link:
http://cgi.ebay.it/Driver-Circuit-B...ternsTorches&hash=item33671d0dd8#ht_847wt_932
My idea is to drive each Led separately, so i need a single 3,7v source.
All led at maximum power need 8400mah!!!!!
Can i put 3 or even 6 parallel 18650 cell to avoid explosion problem?
To charge the battery pack i'll build a internal circuit to avoid charge each elements separately.
Plz help me!
Thanks guys!
I'm Italian, apologize for my english.
I'm about to build on the lathe my first led torch.
As you see from title, I'm puzzling about a definitive solution to Drive a Triple Cree xm-l t6 board.
This is the link:
http://www.led-tech.de/en/High-Powe...REE-XM-L-T6-on-round-PCB-LT-1749_120_117.html
I just read the article describing the explosion of Ultrafire 3000 and I'm really decided to avoid putting the batteries in series to avoid that!
I have 3 2800mah driver
This is the link:
http://cgi.ebay.it/Driver-Circuit-B...ternsTorches&hash=item33671d0dd8#ht_847wt_932
My idea is to drive each Led separately, so i need a single 3,7v source.
All led at maximum power need 8400mah!!!!!
Can i put 3 or even 6 parallel 18650 cell to avoid explosion problem?
To charge the battery pack i'll build a internal circuit to avoid charge each elements separately.
Plz help me!
Thanks guys!