We have just finished machining Stainless Steel QTC battery compartments
for the 10180 and 10280 batteries. These are of the knurled Lug style.
The Cost will be $20.00 each including the QTC pill. Shipping from Peak is
by USPS at $5.00 per package domestic.
The QTC makes the 10180 battery very useful with long run time at low power
and the ability for extreme light output when needed in a very small package.
We also now have 90 degree angle head adapters and straight extenders for
the Eiger/Matterhorn heads. Also for the Shasta/Baltic Sea heads, the El Cap
heads and the Logan/McKinley/Caribbean/Atlantic/Rainier heads.
The Eiger and Shasta adapters are 5/8 inch square for both the 90 degree and
the straight units. The El Cap and Logan adapters are made from 3/4 inch square
material. These units are in both Aluminum and Brass and are in an unfinished
state just as they came off the machine. We have installed the circuit boards
and contact points so they are ready to use.
We did not finish or anodize these because the user may want to drill and tap
them for mounting or to install a clip. As an example, they can be mounted on
the side or front of a hard hat for use as a head light. The adapter goes
between the standard Peak flashlight head and the battery compartment. With a
Logan mounted on each side of the hard hat you will have a lot of light at full
power or dial the power output down with the QTC for long run time. When finished,
unscrew the head and battery compartment from the adapter and put the flashlight
back in your pocket for EDC.
The adapters will work with the new QTC battery compartments and the older non
QTC units and almost all of the lights that we have made in the last 6 years. We
have about 30 of the 90 degree angle adapters and about 6 of the straight units in
each size. These are priced at $20.00 each until we run out.
Contact Peak for these items at firstname.lastname@example.org or fax at 1-623-582-0526.