KnOeFz
Enlightened
I did a small mod to a light I recently started using as edc, the stainless steel Ultrafire SA-R1.
There was a large part sticking out behind the tail cap that I had no use for as I carry it in my (watch) pocket, not on a lanyard or anything. So I decided to try and cut it of. After that I've been sanding for about an hour and the some polishing but I'm pleased with the result, it super smooth again and quite a bit shorter so easier to carry.
This is how it looked when I started out:
Hope you guys like it
There was a large part sticking out behind the tail cap that I had no use for as I carry it in my (watch) pocket, not on a lanyard or anything. So I decided to try and cut it of. After that I've been sanding for about an hour and the some polishing but I'm pleased with the result, it super smooth again and quite a bit shorter so easier to carry.
This is how it looked when I started out:
Hope you guys like it
Last edited: