Hi all,
After using a commercial (modded) canister primary (Halogen) for many years, a I was thinking of re-using the battery-canister \\
and hook it up to a LED head ...
I got a ALU head with suitable dimensions from Alunatec, a 7XPG-R5 module, a MaxFlex6 driver, and a (prolonged signal)
Piezo to operate it.
Although I had some initial ideas to cool the LED array & driver using Aluminum profiles, non of these worked out (mechanically).
So, I'm in desperate need for some advice & new ideas on how to mate the LED/Driver support with the ALU housing (which
would provide the best cooling when submerged).
The inner-diameter of the housing is 50mm ...
Has anyone tackled a similar problem, and succeeded in getting appropriate cooling/heat
transfer to the external housing ?
Thanks & greetz
Patrick
After using a commercial (modded) canister primary (Halogen) for many years, a I was thinking of re-using the battery-canister \\
and hook it up to a LED head ...
I got a ALU head with suitable dimensions from Alunatec, a 7XPG-R5 module, a MaxFlex6 driver, and a (prolonged signal)
Piezo to operate it.
Although I had some initial ideas to cool the LED array & driver using Aluminum profiles, non of these worked out (mechanically).
So, I'm in desperate need for some advice & new ideas on how to mate the LED/Driver support with the ALU housing (which
would provide the best cooling when submerged).
The inner-diameter of the housing is 50mm ...
Has anyone tackled a similar problem, and succeeded in getting appropriate cooling/heat
transfer to the external housing ?
Thanks & greetz
Patrick