Well after a bit of time out from light building/overhauling (first child coming into the world has been keeping me busy) it's time to get back to it.
I've decided to take off the old glands and cable from the can light and put new ones on. But in doing this I have discovered an issue that I am hoping that you enlightened folk can help with...
I've been looking at the Agro glands with strain relief, but to me it seems I have not got standard size threads and holes from the previous ones (I figure they must be some sort of standard as of course they are not custom made, but I cannot find matching dimensions).
Dimensions as best I can measure them on the old ones are:
External thread: 18.25mm
Internal hole/thread (can-lid & light head): approx. 17.5-18mm
The light was produced in Germany if that makes much difference!?!?
Any suggestions and advice are much appreciated.