Results 1 to 1 of 1

Thread: Looking for some help in LED selection & sourcing.

  1. #1
    Join Date
    Jan 2012

    Default Looking for some help in LED selection & sourcing.

    Hello, longtime lurker, first time poster.

    I have a need for an LED that is 12volt, preferably small in diameter 1\2" to 3\4". but yet pretty darn bright. The plan would be that I can machine an aluminum or delrin bushing that the LED can either screw into or be bonded to in some fashion. I would also need to have protective lens. Basically, if you took an nice small diameter aluminum flashlight, that was 12volt, cut off the battery compartment, that is what I am looking for. Not looking to break the bank, something inexpensive of middle of the road would be cool.

    Something like this, except smaller body.

    Any suggestions?
    Last edited by 1in9twist; 01-22-2012 at 09:12 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts