Mechanical Modding Services

[precisionworks]

Ask and you shall receive...
http://olightusa.com/Olight-Accessor...rrior-Tactical

Nice design, I like it better than my spacer & the cost is certainly low.

[Greenbean]

Now to just get my hands on one to see what it's outer circumference is,

And see if the "tip" can be easily snipped off,

I know it's used as a reference if needed to put the battery holder in a light in low light if need be. But the internals of the Olight have a recess inside them to accommodate it.

[T45]

Hi Barry

The work I am interested in having done is on a Sunwayman M20A. Unlike most of the Sunwayman Fans here, I don't care for tail standing on my lights and would like the outside ring of the tail end machined down to the bottom of the lanyard holes. Since the light is aluminum I will need to get the light re finished but at a later time. Here is a picture of the tail end:



Could you give me a price quote for the work? Thank you

[precisionworks]

$25 + Return shipping should take care of that.


Barry Milton
Precision-Gunsmithing.com
iPhone5 voice recognition

[T45]

$25 + Return shipping should take care of that.


Barry Milton
Precision-Gunsmithing.com
iPhone5 voice recognition

ON ITS WAY!

[Shooter21]

Hi Barry can you do a chrome finish on a host and if so please pm me for the price? Thanks.

[precisionworks]

I am not able to offer any type of refinishing service.


Barry Milton
Precision-Gunsmithing.com
iPhone5 voice recognition

[OneBigDay]

I always keep a few titanium McGizmo pocket clips in stock. I can drill & tap the holes & install the clip for $95 + $6 return shipping (USA).

Good afternoon. I had posted late last year about having a McGizmo clip put on my V10RTi. Even though this light is now an ancient relic I would still like this done if you have a spare clip and are up for it. Let me know and I'll get it in the mail in the next week. Thanks.

[precisionworks]

Good afternoon. I had posted late last year about having a McGizmo clip put on my V10RTi. Even though this light is now an ancient relic I would still like this done if you have a spare clip and are up for it. Let me know ...

Please go ahead and send it in. I have a few clips left but I am somewhat backed up And cannot promise a completion date.

[OneBigDay]

Please go ahead and send it in. I have a few clips left but I am somewhat backed up And cannot promise a completion date.

No worries at all, I'm not in a rush. I'll get it in the mail and send paypal and you can get to it at your convenience. Thanks!

[Espionage Studio]

I couldn't find any reference to this after searching, is it possible to bore McGizmo McClicky Paks to 18mm? I might get myself a 2x123 Pak and thought it would nice to use 18650 in it if possible. Seems like they don't have enough metal to allow that however, thanks for the help.

[precisionworks]

... is it possible to bore McGizmo McClicky Paks to 18mm? ... Seems like they don't have enough metal to allow that ...

In theory yes, not too different from boring an E-series. I don't offer that service because the cost of a slip up is many times higher than the potential profit on the job. Sometime I might post a photo of my "drawer of shame" - where mutilated lights go after I've destroyed them. Ironic thing is that there's nothing inexpensive or easily replaced in that collection, just some high dollar titanium tubes

As always the manufacturer is the best place to start when you want something like that. Some of the custom makers will enlarge their tubes but Don will not.