StefanFS
Flashlight Enthusiast
Basic ingredients. Cree XR-E ~3000K on a slab of aluminum, 15 x 30 x 3 mm. Cheap optics from DX et al.
Epoxied and wired.
Generic driver, 350mA to 1-8 emitters.
Result.
2 x 1 Watt spots. Generic driver for 1-3 emitters @ 350 mA.
Same spots from the kitchen door.
Spots in daylight. Made from GU10 DIY led bulb kits, using heatsink and optic. The heatsinks are epoxied to small L-shaped steel support parts. These have been running since may 2011 on a timer, every night.
Eave light. Hardly visible.
New project in testing. 3 x 3 Watt spots for lighting the garden. Finished after the latest CPF outage, will post more photos on it.
/Stefan
Epoxied and wired.
Generic driver, 350mA to 1-8 emitters.
Result.
2 x 1 Watt spots. Generic driver for 1-3 emitters @ 350 mA.
Same spots from the kitchen door.
Spots in daylight. Made from GU10 DIY led bulb kits, using heatsink and optic. The heatsinks are epoxied to small L-shaped steel support parts. These have been running since may 2011 on a timer, every night.
Eave light. Hardly visible.
New project in testing. 3 x 3 Watt spots for lighting the garden. Finished after the latest CPF outage, will post more photos on it.
/Stefan