precisionworks
Flashaholic
The P3X can be run with three different power sources:
When 2x18650 are installed in the tube this is the gap between the body & the extender:
The process of machining a spacer starts with 1" diameter brass rod. First op is facing the end smooth:
The end is then center drilled:
Next a drill is selected that will make a hole that's about 97%-98% of desired size:
- 3xCR123 as designed by the company
- 2x18500 after boring
- 2x18650 using a 1-cell extender & a short spacer
When 2x18650 are installed in the tube this is the gap between the body & the extender:
The process of machining a spacer starts with 1" diameter brass rod. First op is facing the end smooth:
The end is then center drilled:
Next a drill is selected that will make a hole that's about 97%-98% of desired size: