Helo fellow CPFr's. Here is a brand new Tain Ottavino V3. Beautiful and flawless, this has both green trit and glow. $245 shipped in the lower 48. First "I'll take it" in the thread takes precedence over all PM's. Thanks for looking.
Ottavino V3 (AAA)
- Ti-6AL-4V Titanium Shell (65 PCS) / Damascus Shell (27 PCS)
- OP Reflector
- AR Coated Glass Lens
- Beefy brass light engine for maximum heatsink
- Knurling on the head and body
- Split ring hole
- One 4x10mm tritium slot in the tail
- Tail-stand-able
- Tighten off, Loose on
- Dual stage output - 10mA(5 lumen) , 220mA (70 lumen) (low first, high next)
- 13.5mm x 64.7mm
- 0.9V~1.8V
- Alkaline, Ni-MH, primary AAA lithium
- Emitter Nichia 219 4000K High Cri
Operation:
1. Install an AAA size battery into the body tube. ( + ) positive end toward the tail, and ( - ) negative end toward the LED.
2. Fully tighten off.
3. Loose to turn on low.
4. Loose further to turn on high.
IMGIMG
IMGIMG
Ottavino V3 (AAA)
- Ti-6AL-4V Titanium Shell (65 PCS) / Damascus Shell (27 PCS)
- OP Reflector
- AR Coated Glass Lens
- Beefy brass light engine for maximum heatsink
- Knurling on the head and body
- Split ring hole
- One 4x10mm tritium slot in the tail
- Tail-stand-able
- Tighten off, Loose on
- Dual stage output - 10mA(5 lumen) , 220mA (70 lumen) (low first, high next)
- 13.5mm x 64.7mm
- 0.9V~1.8V
- Alkaline, Ni-MH, primary AAA lithium
- Emitter Nichia 219 4000K High Cri
Operation:
1. Install an AAA size battery into the body tube. ( + ) positive end toward the tail, and ( - ) negative end toward the LED.
2. Fully tighten off.
3. Loose to turn on low.
4. Loose further to turn on high.
IMGIMG
IMGIMG
Last edited: