Results 1 to 3 of 3

Thread: Driving CREE XP-L

  1. #1

    Default Driving CREE XP-L

    Hi there,

    I an in the process of modding a Bardic Light as in this thread: (http://www.candlepowerforums.com/vb/...vice-and-Ideas)

    I am using an Arduino to control an LED light ring to facilitate changing the colours (red, amber and green), and wondered if there was a suitable circuit to use to drive the CREE XP-L, at 3.25v Vf and I=3A. I can use PWM on the arduino to set brightness. I'm also using an OP reflector from a Convoy C8

    With all the room in the case, I'm planning on running some heat pipes for the LED to keep things nice and cool. I am trying to keep the original look and feel of the lamp, so will be keeping the switch as is.

    This is my first foray into modding a light, so your guidance is very much appreciated!


  2. #2
    Join Date
    Dec 2011

    Default Re: Driving CREE XP-L

    There are plenty of suitable drivers on Mountain Electronics.

  3. #3

    Default Re: Driving CREE XP-L

    Thanks, I forgot to mention that I'm from the UK so shipping can cost more than the driver.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts