sotyakr
Enlightened
Just received a pouch offered by CPF'er Wong which fits lights such as the LionHeart, and at the other end of the spectrum, the QIII. My application would be EDC of the QIII. The pouch is nicely stitched and assembled of what looks to be good quality materials, certainly a lot sturdier than the OE pouch. It's a the same height, but a bit wider than the pouch supplied with the QIII.
The extra width makes inserting and removing the QIII lens down, somewhat easier.
One gripe I have with the QIII's supplied pouch is the belt loop. It's flimsy and too small. Not so with this replacement. It's quite substantial and has plenty of room to feed a belt through. It's secured with a snug fitting snap on the bottom, which I suppose might make it a bit less secure, but it does take a good tug to unsnap it. There's also a small loop at the top of the belt loop where an included "mini-biner" can be attached. The 'biner can also be stored in a pocket on the front flap.
For $10, shipped from Singapore, I'd say this pouch is more than up to the job and a good deal. At some point I might even have to get a nicer light to fill it! Wong has been offering them in a few different colors on B/S/T ~ Non-Lights.
The extra width makes inserting and removing the QIII lens down, somewhat easier.
One gripe I have with the QIII's supplied pouch is the belt loop. It's flimsy and too small. Not so with this replacement. It's quite substantial and has plenty of room to feed a belt through. It's secured with a snug fitting snap on the bottom, which I suppose might make it a bit less secure, but it does take a good tug to unsnap it. There's also a small loop at the top of the belt loop where an included "mini-biner" can be attached. The 'biner can also be stored in a pocket on the front flap.
For $10, shipped from Singapore, I'd say this pouch is more than up to the job and a good deal. At some point I might even have to get a nicer light to fill it! Wong has been offering them in a few different colors on B/S/T ~ Non-Lights.