GJW
Flashlight Enthusiast
Just wondering if the McR19 would fit the original McLux head.
The IMS17 is just a tad small and the IMS20 is too big.
Thanks
The IMS17 is just a tad small and the IMS20 is too big.
Thanks
-
You must be a Supporting Member to participate in the Candle Power Forums Marketplace.
You can become a Supporting Member.
McR19 in a McLux-I?
- Thread starter GJW
- Start date
Help Support Candle Power Flashlight Forum
GJW
Flashlight Enthusiast
And that answers that.
Thanks Don.
Can you recommend an o-ring size to take up the rattle room when using the IMS17?
Trial and error is driving me nuttier.
/ubbthreads/images/graemlins/smile.gif
Thanks Don.
Can you recommend an o-ring size to take up the rattle room when using the IMS17?
Trial and error is driving me nuttier.
/ubbthreads/images/graemlins/smile.gif
GJW,
Your question got me to thinking about some special "chopped" 20 mm reflectors that were reduced to 18 mm and I have some of these. I tried one in a McLux head and it worked very well with the stock O-ring. I have sent a note on to Wayne for possibly handling a few in the shoppe but in the mean time, if you are interested, send me an E-mail.
Your question got me to thinking about some special "chopped" 20 mm reflectors that were reduced to 18 mm and I have some of these. I tried one in a McLux head and it worked very well with the stock O-ring. I have sent a note on to Wayne for possibly handling a few in the shoppe but in the mean time, if you are interested, send me an E-mail.
tylerdurden
Flashlight Enthusiast
GJW said:
I use some stripped insulation from hook-up wire, cut to the correct length to fit around the mouth of the reflector. Works great.
