Officially launching a limited pre order starting today! Thanks to all that have helped and given input, it’s been a long journey. Hopefully it’s ok if I link the site I made on here, if not I will remove Pointermachineworks.com and I would like to offer 10% off to forum members as a thank you...
So the wheel in the center is the closure mechanism that brings the two halves of the light together closing the battery compartment and the button is on the bottom of the head, it has a bezel that holds the button assembly in and that is what you can see from the side. The way the button is cut...
Finally finished! Its taken me nearly a year since I came up with the idea for this light and now I have a complete working model. Let me know what you think!
Yeah unfortunately it won’t run AA with that driver, does anyone know of a source for drivers that can run both and operate off of a tactile momentary switch? My knowledge of drivers is fairly limited and I would definitely appreciate some suggestions.
As for material right now they will be...
Thanks! Figured out the pictures. Just finished machining the bezel that holds the lens, much harder to make than you would think especially when you only have a mill not a lathe! Pretty sure it’s the thing I’m most proud of on this build so far. Took these pictures in my garage so lighting is...
Hey guys this is my first post on here but I’ve been following the forum for a while. I recently began down the machining career path and am working on a new flashlight design that I will likely be offering in limited numbers.
The design is a side by side configuration with a unique pass...