●-●-● Bombelman Arc LS FluPIC & SSC mod ●-●-●

[bombelman]

This one sat on my desk a long time !
The retaining-ring was not locked with glue or eopxy, but
with SOLDER !! ARGHHHH Too bad solder does not soften by
boiling, like Loctite does... The answer: BRUTE FORCE !! hehehe
I managed to "find the holes" of the retainer and inserted
my needle-nose pliers in them. The head of the body was secured
between rubber and a Craftsman Robogrip...
Luckily solder is "softer" then alu... The retaining-ring unscrewed
after a few hour of teeth-grinding agony...
I managed to do so without damaging the board, retainer or threads...

So anyway, Light-engine was custom built:
0.77" Goldserve FluPIC, piggybacking a custom-sanded copper heatsink,
onto which the Seoul USW0H was epoxied and soldered on.
For light-collamination I used a custom sanded McR-18.
The Old optic and plastic lens were replaced by a coated glass-lens.
(Anti-scratch)...

The proud new owner of this Gem may post his experience here too...

Cheers !!!

Questions, comments and suggestions more then welcome !
(PLEASEEEE, NO PM ! e-mail to george (at) bombelman.com Subject: CPF-CPF-CPF-CPF)

Bezel-shot

Just being sexy...

Sexy-back... Matching slim twisty.

PERFECT Emitter centering !!!

Showing Light-engine, top view.

Showing Light-engine, bottom view.

Turned on, on LOW.... hehehe

 

[Kelvino]

Re: ●-●-● Bombelman Arc LS FluPIC & SSC mod ●-●-●

Why am I getting interested in ARCs now, Bombelman???

And by the way:goodjob:

 

[X_Marine]

Re: ●-●-● Bombelman Arc LS FluPIC & SSC mod ●-●-●

Next time get an old belt to bite on.. much better than grinding teeth.. lol
Good job..

X..

 

[Pumaman]

Re: ●-●-● Bombelman Arc LS FluPIC & SSC mod ●-●-●

very nice. looking forward to the passaround