A19 CREE XR-E 1x123 Flashlight Question

[Manzerick]

hey Folks,

Just ordered this yesterday and was womdering if this head wold work on a 2 cell body?

I just ordered Pablo's Pineapple and think it would be a wild combo..

Thoughts?

 

[Manzerick]

now it also raises the question on which tailcap to use...hmmmm

 

[criollo]

I put on TB's 1 x 18650 body and it works fine with Aw's 18650. I reckon if you use 2 cell body, 17650 should be ok.

10 ohms works fine and someone mentioned 5 ohms (tried the 15 ohms and only works one stage)

No expert here but this what i have found out.

 

[Manzerick]

Ohh cool...Thank You!



Any idea on max voltage on the head? I wonder if 6v+ will make it pop

 

[IsaacHayes]

Yes, max voltage is 6. Actually IIRC Wayne stated that do not use it on 2x123a primarys, that 6 is bad for it. So UNDER 6volts is ok. Max is a single li-ion. Min is 1 primary.

So one cell only, primary or li-ion.

 

[Manzerick]

Perfect!!! I'll keep it to a 600s or equliv

You guys are the best!! Thank You!

 

[knightrider]

Anyone doing the 1.5 cr123 rechargeable route? The shoppe still has those tubes left and the 17500 sounds like it would give more run time.

 

[powernoodle]

I have my Cree A19 GD825 on an L4 body and clicky, eating a 3.7v Pila 168S. I think it looks great, and the thin L4 body and clicky feel good too.

peace

 

[Manzerick]

Hey PowerNoodle,

Any idea on run time with your set-up?

I have my Cree A19 GD825 on an L4 body and clicky, eating a 3.7v Pila 168S. I think it looks great, and the thin L4 body and clicky feel good too.

peace