OrBy
Newly Enlightened
I have a older Z-Bolt laser that is no longer working.
It is a non-leadlight unit - I believe it's the other major maker that start's with the C.
Anyway - I think it's the main driver board that's the issue.
If I apply power nothing happens off the hop but if I apply power and hold the case then simply tap the driver board (pot or some other circuts) it powers up untill I remove power.
Now I know that this is not a very detailed run though of the issue but if anyone has any suggestions I would very happy.
I am adept at working with smt soldering and would have no prob replacing components or even the whole driver board if needed.
Any Ideas?
It is a non-leadlight unit - I believe it's the other major maker that start's with the C.
Anyway - I think it's the main driver board that's the issue.
If I apply power nothing happens off the hop but if I apply power and hold the case then simply tap the driver board (pot or some other circuts) it powers up untill I remove power.
Now I know that this is not a very detailed run though of the issue but if anyone has any suggestions I would very happy.
I am adept at working with smt soldering and would have no prob replacing components or even the whole driver board if needed.
Any Ideas?