Sold/Expired Building a Mag Bi-Pin Hotwire?

[cmacclel]

I have some modules left that I used with the Torch and all my Mag Hotwire builds. These are a tight fit I used to put them in the freezer then heat the body up with a heatgun. You can also take the anodize off with some sandpaper. They measure 1.348"

These where designed for a tailswitch but you can easily take the PCB off the bottom and solder to the Bi-Pin holder directly.

$35 each delivered (US)

 

[curtispdx]

So let me make sure I understand: to use this I'd remove the stock switch and use your tail switch instead and I'd have to use a shortened body too.

 

[^^Nova^^]

Hi Mac,

I am interested in one or two. Do you have any tailswitch kits available to go with these? Did you offer these at one stage, I searched but couldn't find any threads? How much for int postage?

Cheers,
Nova

 

[flashfiend]

Any more of these left?

 

[cmacclel]

Any more of these left?

I have a few left. Once there gone.....there gone for good.

Mac

 

[bigchelis]

I will take one please!

 

[alpg88]

id this [email protected] your paypal email???
i,ll take one.

idk about freezer, but i'll defiantly try if my carbon extinguisher deep freezes it

 

[addictedmatt]

I will take one as well if there are any left!

 

[cmacclel]

I have a total of 6 pieces left.

My PP is [email protected]

Thanks Mac

 

[alpg88]

$35
thanks.

 

[bigchelis]

for $35.....

Thank you,
bigC

 

[choppers]

for $35


Thanks,

 

[357mag1]

I will take two.

!

 

[addictedmatt]

for the last one.