CBAII settings with Powertoolbattery

[Anders]

Hello.

So, I just got me a Hitachi DS14DAL a cordless driver drill.

I am curious if the battery hold 3,0 A as stated
The battery is a Li-Ion 14,4V 3A.

I measure 16,12 V just charged and i don't know which settings to use with my CBAII?

I think it is 4 cells in it but the voltage per cell then is 4,03 V so maybe it is LifePo4 cells in it, then the cells nominal capacity is 3,2 V or?

What settings (Volts) should I choose to end the disharge with?

Maybe Silverfox have any suggestions for me or somebody else with proper knowledge.



Anders

 

[SilverFox]

Hello Anders,

My guess is that it is a 4S2P pack. I would set the CBA for 4 cells and do a discharge at 1.5 amps to get a feel for the pack. The CBA will choose an ending voltage of 11.2 volts, but I would raise that to 12 volts.

Tom

 

[Anders]

Hello Tom.:twothumbs

Thankyou very much for your suggestion, I will give it a try.




Anders