Driver Circuit Board Cree MC-E/ XML/SSC P7/XM-L LED 2-7 Modes AMC7135 3000mA .......

[smilyize]

[/IMG]

can someone please help me point the area to solder from point A to Point B on how to change the modes of this Cree Driver... the only instruction included when I received it is this one:

The driver has 2-7 modes and these can be pre-selected by soldering links on the circuit board.. The modes are achieved by PWM.
The mode options are:
OPTION 1 Low(glowing) - Medium(35%) - High(100%) - Low(glowing) - Medium(35%) - High(100%) -Strobe(10Hz) - Blink(2Hz) - SOS - Beacon
OPTION 2 High(100%) - Medium(35%) - Low(glowing) - High(100%) - Medium(35%) - Low(glowing) - Strobe(10Hz) - Blink(2Hz) - SOS(slooow) - Beacon
OPTION 3 High(100%) - Medium(35%)
OPTION 4 High(100%) - Strobe(10Hz)
OPTION 5 Medium(35%) - High(100%) - Blink(2Hz)
OPTION 6 High(100%) - Medium(35%) - Blink(2Hz)
OPTION 7 Low(glowing) - Medium(35%) - High(100%)
OPTION 8 High(100%) - Medium(35%) - Low(glowing)

thank you so much, to use option 4 ............ have a great day everyone........... smilyize

 

[moderator007]

In this pic from KD. Looks like you would solder a bridge connection between all three S2,S3 and S4 that is if you have the exact same driver. Looking at the pic you will see two small solder pads at each label S1,S2,S3 and S4. You have to make a bridged solder path between the two pads at each label. Solder the two pads at S2 together and two pads at S3 together And two pads at S4. S1 also appears to be last mode memory so it will stay in the same mode it was in when you turned it off. Should come back on in the same mode if you solder the two S1 bridge pads together. Nice update to a good driver by the way. I really like that 3 to 5ma low.

 

[smilyize]

thank you so much, now I have an idea !!! I'll see if I can get it to work the way you explained...

by the way here's the link where I bought it.: Not KD...

http://www.ebay.com/itm/320831558263?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649

the way look at the KD link you replied, it looks very much the same, even though the picture diagram is small, I can figure it better now..... my humble apology beeing a newbie and a million thanks once again.................... smilyize