I have some copper tubing remaining from the TRI SST-Turbo mod:
http://www.candlepowerforums.com/vb...l-Body-Copper-Heat-sink&p=3587202#post3587202
$19 shipped for 2D mag or $25 shipped for 3D mag use.
Let me know the length you need to I'll estimate for you.
The exact length isn't critical as the tail end length don't need to be precise.
Its meant to connect with heat sink extend head transfer to the whole body instead just at the neck.
I had to buy 3ft length to meet minimum purchase. With full copper sleeve heatsink, one can do 5XML or 3xSST-90 onto mag D with confidence.
They are raw tubing, need to grin down the diameter by a mm or so.
They will not go into mag D as is.
http://www.candlepowerforums.com/vb...l-Body-Copper-Heat-sink&p=3587202#post3587202
$19 shipped for 2D mag or $25 shipped for 3D mag use.
Let me know the length you need to I'll estimate for you.
The exact length isn't critical as the tail end length don't need to be precise.
Its meant to connect with heat sink extend head transfer to the whole body instead just at the neck.
I had to buy 3ft length to meet minimum purchase. With full copper sleeve heatsink, one can do 5XML or 3xSST-90 onto mag D with confidence.
They are raw tubing, need to grin down the diameter by a mm or so.
They will not go into mag D as is.
Last edited:
